AGS 20 A blend of exfoliated graphite particles and high-temperature sacrificial lubricants for extreme service applications		AGS 26 A non-staining, non-toxic fiber blended with FDA-approved lubricants for clean or food-grade applications.
	AGS 25 A high-performance, chemically resistant product with bearing pellets. Ideal for the toughest applications		AGS 27 A blend of high performance fibers and chemically resistant lubricants.
	AGS 29 A blend of synthetic fibers and non-staining lubricants for general service.

Recommended Uses - Allstate Gasket's injectable pump and valve sealant combines a malleable packing material with space-age chemistry and technology. The end result is a superior pump and valve packing, material that can be injected while the pump is operating without interrupting production.

Allstate Gasket's injectable sealant is made from a blend of high-tech, non-asbestos, non-hazardous synthetic fibers and carefully selected blends of grease, oils, and other proprietary binders. It is this unique blend of fibers and binding agents that allows the sealant to be run virtually leak free. It does not rely on product leakage for lubrication, the friction heat buildup that so often leads to compression packing failure is eliminated. The sealant's low friction coefficient and non-stick properties help extend equipment life by reducing shaft and sleeve wear.

Allstate's sealants are installed with any flat-bladed tool, such as a putty knife or wide-bladed screwdriver. The material can also be finger-packed into the box. An anti-extrusion ring of appropriate material is placed in the stuffing box around the shaft. A second ring is put in place after the sealant is installed.

When repacking becomes necessary, you do not have to remove the old packing. Just add more sealant packing material by using Allstate's injection gun to inject new packing through a fitting installed on the pump or valve stuffing box.

Allstate's Universal Packing 777 is available in five standard grades to suit a variety of applications. the sealants can be used to replace conventional compression packing in centrifugal pumps, valves, and other rotating equipment where compression packings are being used.

An easy and convenient product to use.

Allstate's injectable sealants are easy to install. The initial installation of packing material is done by hand. Tightening the gland nut compresses the material, forcing to conform to any irregular spaces caused by wear. An anti-extrusion ring composed of suitable sized braided packing material is set at the top and bottom of the stuffing box or packing gland to prevent the sealant from being forced out when pressure is applied.